Simple Intuitive Control
Easy to set up and control of roller garage doors. Choose from single, 2 or 4 channel transmitters that can be hand or wall mounted.
Smart Diagnostics
Each controller is equipped with visual LED’s and audible sounders to assist with any diagnostics during programming or normal use including ‘low’ battery indicator and safety edge activation.
More Choice
Controller options include:
ASK – Bi-directional door status, the transmitter indicates the door position at the touch of a button without leaving the home. Obstacle detection feature providing leading edge protection in accordance with European Legislation, motor torque control to detect additional load before stopping the door.
Technical Support & Training
Our technical department can offer you full training on the installation, programming and fault diagnostics on all our garage door controls.
Product Features
Features of NO9 Controller
The N09 control panel can be programmed to ‘turn off’ the safety edge 50mm from the floor allowing the door to fully close on uneven surfaces. The safety edge can be wired or wireless OSE or resistive. Bi-directional transceivers indicate the position of the door when used with ASK transmitters. Built on energy light (25w) Push button front panel with low battery and mains power LED’s , auto close and audible & visual diagnostics.
Safety Edge Components – Wireless
Parts needed for a ‘wireless’ safety edge include the following.
1 x Bottom Slat Transmitter (TCSP)
2 x Lithium EMBB Batteries
1 x Optical Safety Edge (OSE)
1 x Rubber Profile
2 x Bumpers
The TSCP is powered by two batteries and tests the safety edge before every close operation. In event of any safety edge failure the door can only close in ‘hold to run’ mode.
Features of C10 Controller
Bespoke control panel produced for SWS to their specification. For wireless safety edge only the safety edge can be wired or wireless OSE or resistive. GSM plug-able card for operation from any mobile phone. When used with an alarm, notification on the phone of any attempted break-ins. Bi-directional transceivers indicate the position of the door when used with ASK transmitters. Built on energy light (25w) Push button front panel with low battery and mains power LED’s , auto close and audible & visual diagnostics.
Features of the RDS Controller
Bespoke control panel produced for SWS to their specification for wireless and wired safety edge. The safety edge can be wired or wireless OSE or resistive programming is carried out from the front push buttons making it safer. Seven front panel LED’s to aid programming and diagnostics. Bi-directional transceivers indicate the position of the door when used with ASK transmitters. Built on LED light, auto close and audible & visual diagnostics.
RollSafe – TVNRG868
The safety edge can be wired or wireless OSE or resistive Bi-directional transceivers indicate the position of the door when used with ASK transmitters. Built on energy light (25w) push button front panel with low battery and mains power LED’s auto close and Audible & visual diagnostics.
Safety Edge Components – Wireless
Parts needed for a ‘wireless’ safety edge include the following.
1 x Bottom Slat Transmitter (TCSP)
2 x Lithium EMBB Batteries
1 x Optical Safety Edge (OSE)
1 x Rubber Profile
2 x Bumpers
The TSCP is powered by two batteries and tests the safety edge before every close operation. In event of any safety edge failure the door can only close in ‘hold to run’ mode.
Contact us for more information if required
It is the roller shutter that is fire rated rather than the Ellard motor. Therefore you would have to refer back to whom you bought the roller shutter from
Here at Ellard ltd we specialise in supplying industrial door motors and supply a comprehensive range of motor types and models. This includes, direct drive, flange, sectional, garage door and tubular motors. Our selection is vast, so for a comprehensive list of our products and specifications you can visit our dedicated pages or get in touch with our expert team.
Yes, our Nubia traffic barrier has built in intelligent controllers which offer obstacle detection and built in lights to make them easy to see in the dark or in bad weather.
Direct drive motors remove the need to use an elaborate system of cogs. This means that the full power of the motor goes straight into the pulling mechanism, making it an extremely efficient motor. Without the extra mechanisms, it also has a very low sound output comparatively to other methods.
Fire motors are often connected to your fire detection system and activate if fire is detected on your premises. They quickly and efficiently close helping to contain the fire and keep your employees/customers safe from the dangerous area. Government legislation requires that all fire doors must have an automatic function and all Ellard fire motors comply with the latest rules and regulations. All motors can be set to a Smoke Curtain mode, and our new Fire Door Control Panel has a panic circuit function to guarantee a means of escape.This allows you to re-open the shutter 3/4 then immediately re-close when fire alarm is still active.
Yes, our gate automation systems can be linked to keypads, switches, intercom systems and key switches, dependant on your specifications or security requirements. Take a look at the range of controls and accessories available for gate automation.
Yes, we ensure that your sectional doors have easy wiring to add safety and access accessories.
High speed motors are used for a wide range of purposes and can increase the efficiency of companies when time is of importance. Beverage, food, car and chemical factories often use high speed motors both to increase productivity and provide a security barrier. They can also be interlocked to create a airlock function
Our track sections are cold rolled and in standard lengths of 2,000, 2,500 and 3,000mm and can be used for both side or top fixing. If you would like to learn more about our sliding door gear then please get in touch with our team.
Tubular motors are the most common place motor for roller garage doors and shutters. They provide a durable, fast and quiet solution for both light and heavy applications. Tubular motors can be plugged into the mains through our easy fit panel to give you low voltage at the key switch or are backed up with battery power. Additionally, we provide garage door automation for sectional and balanced doors.
Copyright 2020 – All rights reserved
Door Spares UK Ltd | Company Registration: SC647824